Author: Sorting Last Post on Top Message:
MOTIVATED@LAST Posts: 15,456
8/18/13 3:31 A

As your cadence drops and you do more work with each strike, but fewer strokes, your muscles start to work anaerobically, rather than aerobically to generate sufficient power.

While working anaerobically generates more power, you can't keep it up for long.

So to maintain your power output, you should be aiming at a higher cadence, but less work each stroke.


SP_COACH_DEAN SparkPoints: (116,635)
Fitness Minutes: (245,387)
Posts: 15,290
8/18/13 1:50 A

Hi, P

The basic idea behind shifting gears is to maintain the maximum power output you can sustain over the entire length of your ride. Basically, you want to figure out the maximum intensity level (heart rate) you can maintain for the amount of time you expect the ride to take, and then you translate that into the most rpms you can maintain on flat ground with no wind in your most efficient gear. Say, for example, that the maximum power output you can maintain for 60 minutes allows you to pedal at the rate of 80 rpms in your highest gear on flat ground with no wind. Obviously, if you run into a hill or some wind, maintaining that rpm without changing gears is going to raise your heart rate, which means you'll run out of steam and won't be able to maintain your best effort for the whole ride. So, you change gears enough so you can keep pedaling at 80 rpms and same heart rate while you're going up the hill. That way you won't run the risk of tiring out your legs too early, or making the opposite error--reducing your rpms and slowing down more than you actually need to.

You don't HAVE to do it this way, but it probably is the simplest way to make sure you're maximizing your performance in a race situation. You can use your training rides to figure out what number of rpms works best for you for a given distance, and what gears allow you to maintain that under different circumstances, like hills and wind.

Hope this helps.

Coach Dean

8/17/13 9:42 P

I have always been taught that you use gears to maintain a specific leg cadence i.e. number of leg cycles per minute, shifting up or town to maintain that cadence. Some cyclists are "spinners" high cadence riders others are more "power rider" using leg strength to compensate for a lower cadence. Higher gears should in fact increase your speed at a given cadences once you get more wheel revolutions per leg stroke by using lower gears on hills you can maintain your cadence.

Here are two good websites with explanations in depth.

PATTIMET Posts: 657
8/17/13 1:51 P

I've been a recreational biker for a long time- speed was never an issue. I always rode using the higher gears - less peddling for more speed - yes the peddling is harder but you get more distance for your bang - right - now I've done my first triathlon, and am training for my second - my weakness is the biking. Everyone is telling me to use lower gears for hills - I don't understand the logic for this - can anyone tell me - please - I'd greatly appreciate some tips for biking.

Page: 1 of (1)  

Other Fitness and Exercise Topics:

Topics: Last Post:
Fitbit Sync 2/12/2017 10:37:54 PM
The Best Part About Swimming 5/17/2017 2:54:43 PM
Is this really an exercise? 1/21/2017 9:27:55 AM
need suggestions 10/13/2016 4:50:39 PM
holding your stomach in during workouts 2/12/2017 9:12:56 PM